Siam Green Engineer Co.Ltd start energy saving project reduce hot water cost compare with electric heater and SGE Heat Pump.
which can save energy more 60% use 3 point installation and central point supply separate 3 zone the project aim goal with reduce CO2 and energy cost .
Training SGE Heat Pump ” Leafs ” Thailand brand
Test run SGE Heat Pump already .
3 point installation with SGE Heat Pump model 25kW : central station .
Checking before installation SGE Heat Pump so our team planning and design.
drawing and make real picture install heat pump .
Checking again before design.
At The SIS Kata site prepare install SGE Heat Pump and hot water system.
Try to clear at site installation heat pump picture.
Sent SGE Heat Pump Model 25 and Pressure storage tank 4,000 Liter Zone C and Zone A , B soon on January close up to install.
SGE Start installation SGE Heat Pump now move to control room already.
SGE Team try to clear and move all heat pump to control room.
SGE Team start and prepare heat pump and pressure storage tank before move to site tomorrow. and show picture SGE Heat Pump.
This project use model 25kW x 3 units by separate 3 points zone design.
Specification SGE Heat Pump model 25kW is
– Heating capacity 25.4
– Cooling capacity 20.9kW and ( 71,314 Btu/h )
– Hot water recovery rate 729 Lph.
– Water inlet Temp 30 oC
– Water outlet Tem 60 oC
– Max hot water outlet Temp 70oC
– Air flow rate 4,247 m3 / hr and 2,500 cfm.
– Compressor Scroll type , 1 unit with Refrigerant R134a , 380V/3Ph/50Hz
– Power at recovery rate ( included all electrical parts is 5.84kW
– RLA@ recovery rate 12.1A and FLA 17.4A
– Casing material SUS304 Stainess Steel
– Dimension 880mm x 675mm x 1650mm.
– Net weight ( approx ) 245kg.
– Water inlet – outlet = 1″
– Condensated drain 3/4″
siamgreenengineer
This project use model 25kW x 3 units by separate 3 points zone design.
Specification SGE Heat Pump model 25kW is
– Heating capacity 25.4
– Cooling capacity 20.9kW and ( 71,314 Btu/h )
– Hot water recovery rate 729 Lph.
– Water inlet Temp 30 oC
– Water outlet Tem 60 oC
– Max hot water outlet Temp 70oC
– Air flow rate 4,247 m3 / hr and 2,500 cfm.
– Compressor Scroll type , 1 unit with Refrigerant R134a , 380V/3Ph/50Hz
– Power at recovery rate ( included all electrical parts is 5.84kW
– RLA@ recovery rate 12.1A and FLA 17.4A
– Casing material SUS304 Stainess Steel
– Dimension 880mm x 675mm x 1650mm.
– Net weight ( approx ) 245kg.
– Water inlet – outlet = 1″
– Condensated drain 3/4″